1 / 2
Tronxy XY-2 Pro Dressup Kit — zdjęcie 1
1 / 2

Tronxy XY-2 Pro Dressup Kit

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

V-slot covers and endcaps for dressing up the Tronxy XY-2 Pro frame.

Ocena
5 / 5
Polubienia
9
Pobrania
78
Wydruki
1
Wyświetlenia
635
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v2.0

As the title would suggest, this kit has little value aside from aesthetics.  The intent of this kit is to add a splash of color to an otherwise dull and unattractive Tronxy XY-2 Pro.

The only practical uses I can think of for this kit are that the v-slot covers will prevent stray wisps of plastic from accumulating in the lower extrusions, and, as I have a preference for printing on bare glass, printing the v-slot covers, especially the longer ones, are a really good indicator as to how well an ABL system is working with a severely misshapen bed, as is the case for my Tronxy XY-2 Pro.

Where the v-slot covers are concerned, there are several files who's names indicate their unscaled printed length.  Everything in this kit is intended to be printed on the Tronxy XY-2 Pro, so any covers that won't fit the build plate of the Tronxy XY-2 Pro are ½ length.  For example, the top cross-member of the Tronxy XY-2 Pro measures 343mm.  The files intended for that extrusion, “V-Slot_Cover_171.5mm.stl” and “V-Slot_Cover_2H_171.5mm.stl” each measure 171.5mm.  The reason for four files with covers measuring 171.5mm is that the very top of that cross-member has 4 screw-holes for the M5 hardware connecting it to the 20x40 vertical pillars.  The “2H” in the latter of the two files, if you haven't guessed, stands for “2 holes”.  The files named “V-Slot_Cover_1OSH_171.5mm.stl” and “V-Slot_Cover_1ISH_171.5mm.stl” indicate respectively “1 Outside Hole” and "1 Inside Hole" are intended for the lower front 20x40mm extrusion.  The top v-slot on that extrusion use the “1 Inside Hole” and the bottom v-slot uses the “1 Outside Hole” file.

The 20x20 endcaps for the Ender3 are on either side of the top cross-member.  For my build of the Tronxy XY-2 Pro I use the endcap titled “20x20_Endcap_2S.stl”.  It should be oriented with the 2 v-slot guides to be facing the bottom and rear of that upper extrusion.

Back to the v-slot covers…  This should go without saying, yet here it is:  Do NOT install any of these v-slot covers where the pom wheels travel.  I'll also note that none of the lengths on these covers take into account any customization's you've made, attachments etc.  If you don't feel like remodeling any of these pieces to fit your machine customization's, you could print a slot cover that's just a bit longer than the opening you'd like to cover, and trim it down with flush cutters.

Tagi