1 / 3
FT EMS SWC V2 for Smaller Print Beds
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of Fizzy's EMS for the Ender/Switchwire conversion modified to be printable on smaller bed sizes.
- Ocena
- 5 / 5
- Polubienia
- 41
- Pobrania
- 191
- Wydruki
- 3
- Wyświetlenia
- 756
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (6)Wydruki i komentarze (Wydruki: 3) (Komentarze: 5)Remiksy (0)Kolekcje (62)Powiązane
This is a remix of Fizzy's EMS for the Ender/Switchwire conversion. It's been modified to print on smaller bed sizes (200mmx200mm minimum).
Modifications include:
- Main section split into 4 smaller sections (PSU main, PSU subframe, electronics main, electronics subframe)
- Cable duct split in 2 to allow PSU side and electronics side to mount on the y extrusion
- Heat set insert and screw holes added to join main and subframe sections (same concept of Fizzy's original EMS design)
- Designed subframe clamp to allow both subframes to mount to the y extrusion
- Area behind the power input of rear frame removed
- Corner of rear section removed to allow wiring/cables from the z chain to passthrough
All instructions and print settings remain the same. In addition to the original BOM, this remix requires:
- 4 x heatset inserts for each main frame section
- 4 x M3x8 screws to join the subframes to their main frame sections
- 1 x M5x10 BHCS screws to mount the frame
CHANGE LOG
8-Dec-23
- Fixed an issue found when slicing the main electronics and PSU frames. New files uploaded.