1 / 3
FT EMS SWC V2 for Smaller Print Beds
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix of Fizzy's EMS for the Ender/Switchwire conversion modified to be printable on smaller bed sizes.
- Rating
- 5 / 5
- Likes
- 41
- Downloads
- 191
- Makes
- 3
- Views
- 756
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
This is a remix of Fizzy's EMS for the Ender/Switchwire conversion. It's been modified to print on smaller bed sizes (200mmx200mm minimum).
Modifications include:
- Main section split into 4 smaller sections (PSU main, PSU subframe, electronics main, electronics subframe)
- Cable duct split in 2 to allow PSU side and electronics side to mount on the y extrusion
- Heat set insert and screw holes added to join main and subframe sections (same concept of Fizzy's original EMS design)
- Designed subframe clamp to allow both subframes to mount to the y extrusion
- Area behind the power input of rear frame removed
- Corner of rear section removed to allow wiring/cables from the z chain to passthrough
All instructions and print settings remain the same. In addition to the original BOM, this remix requires:
- 4 x heatset inserts for each main frame section
- 4 x M3x8 screws to join the subframes to their main frame sections
- 1 x M5x10 BHCS screws to mount the frame
CHANGE LOG
8-Dec-23
- Fixed an issue found when slicing the main electronics and PSU frames. New files uploaded.