1 / 2
Drybox Dessicant Holder with 120mm Fan
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A desiccant container that has a grill and is compatible with a 120mm PC fan for more effective drying.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 79
- Wydruki
- 0
- Wyświetlenia
- 597
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (17)Powiązane
BOM
- 120mm PC FAN
- Silica gel beads (diameter ≥ 1.8mm, most beads are compatible)
- 4 fan screws
Instructions
- Print as shown in the photo. Supports off for the holder; supports on for the lid. I recommend PETG.

- PETG is good because it is flexible and has very good layer adhesion. The narrow ribs are quite fragile in PLA
- PETG is also good because it is more stringy. In this model, a stringier print means the silica beads are better retained!
- I suggest doing the assembly in your drybox container, since the beads tend to spill
- Fill the holder with silica gel using a teaspoon
- Slide the lid on, as shown in the picture
- Screw the fan into the holder using the fan screws
- Over a trash can, gently vibrate the holder so that all the fractured silica particles fall in the trash rather than making a mess in your drybox