X-Shot Longshot FAMAS Carrying Handle with 2 degrees Picatinny
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
As a certified Metal Gear Solid enjoyer, I designed a FAMAS carrying handle for the X-Shot Longshot. Picatinny ofc (2°)
- Ocena
- 0 / 5
- Polubienia
- 43
- Pobrania
- 247
- Wydruki
- 0
- Wyświetlenia
- 2544
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Update April 2024 - I suggest printing the carry handle in two parts, dovetailing it at the picatinny rail. This allows you to print it side down, costing less support material and also getting a more optimal print orientation for stronger mount on the carry handle.
Since the carrying handle acts as a big riser, I added a 2° angled picatinny rail.
I wanted it to look correct aesthetically, so the sight picture is a tad odd due to the overall height. With both eyes open on a lower profile red dot, your left eye is the one seeing the dot.
Bed size: 256 × 256 × 256 mm
Print Orientation: I printed this diagonally for my bed size.
I printed mine right-side up, which created a lot of support waste. You could try printing it upside down; just be aware that the rail is on an angle.
Mounts can be printed with the flat side down.
Infill: 5 walls, 40%
Hardware: 2x M3x30 , 2x M3 nuts
Tried using variable infill with 100% at the bottom bit where it mounts to the top of the blaster.
Also used variable layer heights at the top "fins" for smoother look.
V2 has a slightly lowered Picatinny rail.