1 / 6
Sloped bed shims for Creality K1, K1C and K1 Max — zdjęcie 1
1 / 6

Sloped bed shims for Creality K1, K1C and K1 Max

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

These can be used in conjunction with the shims made by @NeedItMakeIt to further improve the printer's bed leveling

Ocena
5 / 5
Polubienia
246
Pobrania
2983
Wydruki
6
Wyświetlenia
12 190
Oceny
6

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Recommended slicer settings:

  • Layer height: 0.1
  • Initial Layer height: 0.1
  • Infill: 100%

Print material: 

Preferably ABS+ or ASA, although I've printed it using PLA and it's holding up well.

 

Tutorial:

A good tutorial on how to use the shims was made by the creator of the original design I remixed from, @NeedItMakeIt. The installation process is the same with my sloped shims:  

 

The official method for bed leveling (by tightening the z-axis screws) and the shims made by @NeedItMakeIt help greatly to improve the bed leveling range, but because the printer has 3 z-axis screws, with a single screw on the side closer to the back of the printer, if the bed is tilted to one side, you can easily correct it on the side that has 2 z-axis screws by putting a shim on only one of the corners, but things get complicated on the side with the single screw.

 

Let's say the side of the bed that is closer to the front of the printer has a heigh of 0.434 on one corner and 0.026 on the other. To solve this you'd just have to put a 0.4mm shim on the corner that is lower. But things get complicated with the single z-axs screw that is on the back, because if those same measurements were on the side of the bed closer to that screw and you put a normal 0.4mm shim on it, you would just just elevate the height of both corners by 0.4mm.

 

So let's say you used a sloped 0.4mm shim instead, then (in theory) the higher corner would go up by only 0.1mm and the lower corner would go up by 0.4mm, so the heighs would become 0.534 and 0.426 respectively, a difference of ~0.1mm.

 

This is my printer's bed before and after using a sloped shim (I rooted and installed Mainsail on the printer between the two images, that's why they look different):

 

 

There's two .3mf files for download, the shims from each file are sloped to a different side, and inside each file there's shims from 0.2mm to 1.0mm. The way the slopes work is that on one side of the shim will have the height indicated by the number on it, and on the other side the height will be 0.1mm. So, for example, these are the measurements for the piece that has “0.7” written on it:

 

 

I've also included the .f3d files I made, based on @NeedItMakeIt's original project, in case you wanna make any adjustments to it :)

 

Tagi