1 / 4
EVA 2.4 combined filament sensor and filament cutter — zdjęcie 1
1 / 4

EVA 2.4 combined filament sensor and filament cutter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Filament sensor (mechanical) and cutter to suit eva 2.4 and LGX lite extruder

Ocena
0 / 5
Polubienia
12
Pobrania
52
Wydruki
0
Wyświetlenia
1147
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU Lesser General Public License

This toolhead  filament cutter and sensor for EVA 2.4 with LGX lite

Requires:

1 x 4mm ball bearing
2 x m3 nut (1 for cutting face 1 for spring tension)
1 x #17 craft blade
2 x M5 bolts + nylock nuts
1 x mouse button
hot glue ideally to secure switch and connector
1 x JST XH 3-pin male header 
M3 tap
Epoxy glue for blade
Something to cut the blade down 
M3 Heat set inserts x 4
1 x Pen sprig
bunch of m3 bolts assorted sizes
m3 washer to go between lever and spring

top and bottom lever should be rotated so they are flat on the bed. You do need support on. but you can block some of it out on the bottom section 

i printed in petg 0.2 layer height 0.4 line width

if you need to edit design here is link to tinkercad so you can tweak as required

https://www.tinkercad.com/things/39X3LkbiWIc-copy-of-eva-24-filament-cutter-and-filament-sensor?sharecode=UktHVt3ucBcFMHz1ZTN4Gwv7BM_8sXxIwQ2gXBfnKvI

Tagi