Air Intake and shields for Comgrow laser cutter cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An Air Intake to help pull air across and out of a Comgrow laser cutter cover. This allows you to keep the cover zipped.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 212
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial
A three-part air intake to be used with a Comgrow laser cutter cover.
This allows good intake air to come from the front right of the enclosure and get pulled across the laser bed to the back right exaust port. Allowing the cover to be fully zipped, without the fan pulling in the cover, while also blocking the stray laser from being able to escape out the side using the two sheilds to the left and right of the intake, since the cover will slightly raise on the side.
(could likely be combined to a single part, but would make it harder to print without supports)