Trunion Mount with Detents
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A trunion mount that provides +-25 degree or +- 50 degree detented tilting. Overall width is 87mm.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 113
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Two simple parts to print. Print the one with bosses orientated as shown in the photo. You will need a 8-32 x 2" SHCS, an 8-32 thin, self-locking nut, a pair of 5mm diameter balls preferably steel or stainless steel, a pair of .187" OD x .50" long compression springs with F&G ends and a pair of M8-1.25 set screws. Note the model of the part with the bosses does not include the M8-1.25 threads. The required .267" bore is provided for tapping with a bottoming, chip removal tap. I would make the threads thus but if you want to try your hand at modeling the thread in the part that's a great learning exercise. Either way, enjoy…