1 / 5
Silica Gel Desiccant Holder Sunlu S2 — zdjęcie 1
1 / 5

Silica Gel Desiccant Holder Sunlu S2

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Silica Gel Holder for drying in Sunlu S2

Ocena
4,5 / 5
Polubienia
109
Pobrania
461
Wydruki
5
Wyświetlenia
3519
Oceny
6

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Share Alike

This is a Holder for drying reusable silica gel in a Sunlu S2 Filament Dryer. It is designed for  reusable Silica Gel with diameter 2mm-4mm, for example this:

https://www.chemdiscount.de/chemikalien-von-a-bis-z/silica-gel/silica-gel-lose/silica-gel-lose-orange-mit-farbindikator/1kg-silica-gel-mit-orangem-indikator.html


Print 2 Plates, 1 lid and 1 tub. 

Assembly:

Both plates are printed with 3 assembly sticks, which fit into the 3 holes on each side of the tub. Take the first plate press the 3 assembly sticks into the 3 tub holes, to combine the pieces. Repeat on the other side. For better stability and fit apply some glue to the contact area of plate and tub.

You also have to glue 4x2mm magnets in to the holes of the lid and the tub.

There is also a spout for safer handling of the silica gel:

https://www.printables.com/de/model/746162-spout-for-silica-gel-holder-sunlu-s2

There is also a Funnel for safer handling of the silica gel:

https://www.printables.com/de/model/749478-funnel-for-silica-gel-holder-sunlu-s2

There is also a Silica Gel holder with wallholder for your dry box:

https://www.printables.com/de/model/777510-silica-gel-holder-for-dry-boxes-with-wallholder

 

Version 2 released 02.2024:

Changed the alignment sticks to shorter alignment nubs. The alignment sticks tend to break too easy while assembly. Shorter alignment nubs should prevent breaking.

ASA Version added:

I added a Version for ASA or ABS.  When the holder is very full, the PETG Version deformed over time. So I added a ASA Version which works better on higher temperatures. This version is without allignment pins. But it also holds very good with super glue. The standard lid works with the ASA Version.

 

Print Option:

Bambu Lab PETG / ASA

15% Infill

 

If you have any questions, feel free to ask.

Tagi