1 / 1
Sabatons for fysetc MGN9 hollow rail — zdjęcie 1

Sabatons for fysetc MGN9 hollow rail

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

If you want more mounting points for your fysetc hollow rail, you're in the right place.

Ocena
0 / 5
Polubienia
5
Pobrania
15
Wydruki
0
Wyświetlenia
313
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

These hollow rails are an interesting concept. They are made by fysec, and currently the sizes that I want are not stocked, so I cut a longer rail down with an angle grinder (then tidied up on a bench grinder). The weight saving is substantial. However, the two sizes I wanted both result in an uneven pattern of holes, with the endmost hole “open” and not having a mounting point for an M3 screw.

These sabatons work around this limitation. You glue these things in under the rail, in the obvious-fitting places. There's a just-over-half-size sabaton in case you cut the rail right in the middle of one of these slots.

Glue them underneath the rail anywhere you want to create an M3 mounting point. Use a quality 24 hour epoxy like Araldite, mix it well and ensure it is cured properly before putting any load on the new mounting points.

Tagi