Bath sailboat 2.0, vase mode, fully functional toy in <30 mins
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This sailboat for the bath prints fast! Vase mode body and mast, single layer sail.
- Ocena
- 5 / 5
- Polubienia
- 85
- Pobrania
- 436
- Wydruki
- 2
- Wyświetlenia
- 1626
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution
Print the boat in vase mode, and the sail in regular mode.
The sail is one layer thick at 0.2 mm. It is a little tricky to grasp off the print bed just because it is thin. Once you have a corner off the bed, it should come off easier. Make sure to let it cool so you don't permanently bend it as you pull it off.
The mast is a bit wiggly as it prints, resulting in some surface roughness. This may be mitigated somewhat by keeping the print area ventilated (so it cools faster) and by slowing down the print for the mast portion. But it works well at full print speed if you don't mind the minor imperfections.