Flsun V400 CPAP fan mount for enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Get fantastic cooling with this CPAP / WS7040 fan mount for enclosures. Simple and fast print.
- Ocena
- 0 / 5
- Polubienia
- 40
- Pobrania
- 99
- Wydruki
- 0
- Wyświetlenia
- 1685
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Get fantastic cooling with this CPAP / WS7040 fan mount for enclosures based on this design.
Some noise reduction by covering the fan properly.
No screws necessary. Very simple print (no supports). The printed version uses generic black PLA.
I've used this model for cooling ducts and how to do the fan control. The Bondtech version works well with the original print head.
Connecting the fan controller board to the printer controller board:
Based on the original description here. It works well, but will start the fan at full speed until the main controller has booted.
Gray lead in this picture:
Connect that to the bottom most connector (in relation to the picture), purple connector.
Only a single lead is necessary.
Change the following in printer.cfg:
[fan]
pin: PC2 # was originally: PB1