Yoopai Enclosure Light Bracket End Caps
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
End caps for the sharp metal light brackets
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 354
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This is an end cap for the light brackets on the Yoopai enclosure LED bar. I found them to be a bit sharp and was concerned that they might start cutting through the cloth of the enclosure.
These are very small parts. I printed with a .4 nozzle in PLA. 100% infill, and print slow (I used 40mm/s). Make sure to select “Print Thin Walls” in Cura. They will most likely need to be reoriented once loaded into your slicer. Make sure they're standing up tall.
They're made to have a bit of room around the perimeter but friction fit the thing dimension of the bracket. This will pop off if you pull the LED bar off and move it. They will not fall off otherwise.