Syringe pump adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter to use normal syringes on dental syringe pump Updated 02 jul 24
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 24
- Wydruki
- 1
- Wyświetlenia
- 863
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
This a syringe pump used by dentists, i think for anesthetic.
They usually take special prefilled syringes that fit inside a metal tube that's not in the picture here.
Normal syringes does not fit in the tube, so i drew up a quick proof of concept to mount a normal syringe. The syringe can be slotted in and a clip over to lock it in place and stiffen the slot so it doesn't break under the pressure when you squeeze lever.
The syringes must be of the kind that has a breakable plunger, and it should have a 'Luer lock' for the needle, i made that slot for a 3ml syringe.
You need:
1x Syringe pump. linked below.
4x M2*10
A teeny tiny bit of PLA
And some syringes, of 3ml or 5ml
To fill syringes with lube:
Pull out the plunger.
Snap off the rear part of it so you only have the rubber part with a stubby end.
Fill syringe with lube from the rear.
Insert the short now plunger back in.
Update notes:
Remodeled the bracket and clip.
Added support for 3ml (10,5mm OD) Syringe
Added support for 5ml (14mmOD) Syringe
Todo:
add support for standard solder flux syringe. 10ml (18,5mm OD)
Syringe: https://www.aliexpress.com/item/4001134230384.html
Pump thing: https://www.aliexpress.com/item/1005004397559424.html