Ryobi PCL702 Hand Vacuum Extension
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fit's the Ryobi PCL702 ONE+ 18v Wet/Dry hand vacuum. Tapers to a smaller point than the standard crevice tool.
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 126
- Wydruki
- 1
- Wyświetlenia
- 638
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
Wanted an extension that tapered down to a narrower opening than the standard crevice tool and also wanted something I could print out of TPU to be able to have some squeeze and give to get into even tighter spaces without worry about damaging/scratching surfaces or the tool breaking.
There are two STLs attached.
The version with built-in support is designed to be printed in TPU with a corse layer height between .28 and .32 mm. Using a well tuned TPU profile, the support section should tear away cleanly with a little effort. Print it vertically with an 8-10mm brim for print stability.
Also is included is a version without built-in support is you prefer to add your own.