threaded through hole with slot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made this for a heated drybox for the heater, but it should work with any standard 2 conductor electrical wire.…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 79
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I made this for a heated drybox for the heater, but it should work with any standard 2 conductor electrical wire.
Threaded parts designed for a 20mm hole, but flange should work with up to a 26mm hole.
Has a slot in both parts to allow you to place over a wire without having to cut ends to get wire through.
Might recommend an oil or lubricant on back nut as it can be a little tough to thread dry, but once its tightened down it is not going anywhere.
Print Settings
Printer Brand:
Creality
Printer:
CR-10
Rafts:
Doesn't Matter
Supports:
No
Resolution:
.2
Infill:
40%
Filament: generic pla
Category: DIY