B&Q Nano G2 Ultra Extended Battery Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An extended battery cover for the back of a B&Q Consulting Nano G2 Meshtastic device.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 320
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A battery cover for the back of a B&Q Consulting Nano G2 Meshtastic mesh device. This was designed to use all the original hardware and have the smallest affect on the original form factor.
This design accommodates a 1200mAh LiPo battery that measured 40mm (L) x30mm (W) x 10mm (H).
The battery I used was listed as “KBT 3.7V 1200mAh Li-Polymer Battery: 103040 Lipo Rechargeable Lithium-ion Replacement Batteries with PH 2.54 JST Connector, PH1.25/2.0 JST Connector for Replacement - 8Pack” on Amazon" Note: You'll have to swap the polarity of this battery for compatibility with the Nano G2 board.
Print Settings:
Print with the cavity facing the build plate and supports with other settings as desired.
Assembly: Remove the 4 bottom nylon bolts and nuts as well as the original battery cover. Keep at least 3 of the original backing plates attached. Affix battery to the device in the upper opening with double sided tape or glue. Attach your 3d printed battery cover using the 2 bottom nylon bolts/nuts in their original orientation and flip the middle two bolts so that the face is on the back of the device and the bolts are now on the front.