1 / 3
B&Q Nano G2 Ultra Extended Battery Cover — image 1
1 / 3

B&Q Nano G2 Ultra Extended Battery Cover

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

An extended battery cover for the back of a B&Q Consulting Nano G2 Meshtastic device.

Rating
0 / 5
Likes
2
Downloads
24
Makes
0
Views
321
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

A battery cover for the back of a B&Q Consulting Nano G2 Meshtastic mesh device. This was designed to use all the original hardware and have the smallest affect on the original form factor.

This design accommodates a 1200mAh LiPo battery that measured 40mm (L) x30mm (W) x 10mm (H).

The battery I used was listed as “KBT 3.7V 1200mAh Li-Polymer Battery: 103040 Lipo Rechargeable Lithium-ion Replacement Batteries with PH 2.54 JST Connector, PH1.25/2.0 JST Connector for Replacement - 8Pack” on Amazon"  Note: You'll have to swap the polarity of this battery for compatibility with the Nano G2 board. 

Print Settings:
Print with the cavity facing the build plate and supports with other settings as desired.

Assembly: Remove the 4 bottom nylon bolts and nuts as well as the original battery cover. Keep at least 3 of the original backing plates attached. Affix battery to the device in the upper opening with double sided tape or glue. Attach your 3d printed battery cover using the 2 bottom nylon bolts/nuts in their original orientation and flip the middle two bolts so that the face is on the back of the device and the bolts are now on the front. 

Tags