Ender 3 V3 SE Fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dual or single 5015 cooling fan bracket for Ender 3 V3 SE printer.
- Ocena
- 4,333 / 5
- Polubienia
- 270
- Pobrania
- 1120
- Wydruki
- 6
- Wyświetlenia
- 10 495
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Made for 5015 blower fans.
Dual mount and Single mount options.
No additional hardware required, mounts with OEM hardware.
No need to relocate BL-Touch.
No hardware needed for blower fans. This design does not require you to mount the fans with screws, as it is held in place by a friction fit. However, the screw holes are still included in the design for alternative mounting with screws or even zip ties.
Drop-in Replacement.
Minimal supports needed and easy to remove.
________________________________________________________________________________________________________________
Material: ABS or PETG recommended.
Speed: Slower = Better, since model has some overhangs and bridges. Can be printed faster, but quality may suffer. Default speeds or Slower recommended.
Supports: Make sure to enable normal support, and “on build plate only”.
Only 3 places NEED SUPPORT. Under the duct inlet on both sides, and in the slot shaped hole on the outside of the right fan duct. (See Images for reference). Any other supports are up to you.
Inside the duct DOES NOT need supports and will be hard to remove, which is why you should use the normal supports on build plate only.
Orientation: As shown above.
Layer Height: 0.2mm
Walls: 3
Infill: 15%
Brim: Inner and Outer
Top/Bottom: 3
________________________________________________________________________________________________________________
Note: The less material file is still a work in progress…