1 / 7
Air duct for 120mm fan on Iceriver KS0, KS0 Pro, KS0 Ultra, AL0 and RX0 miners — zdjęcie 1
1 / 7

Air duct for 120mm fan on Iceriver KS0, KS0 Pro, KS0 Ultra, AL0 and RX0 miners

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Air duct for Iceriver KS0, KS0 Pro, KS0 Ultra, AL0 and RX0 miners designed for mounting a 120mm fan to lower temps.

Ocena
0 / 5
Polubienia
15
Pobrania
302
Wydruki
0
Wyświetlenia
1515
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Share Alike

This air duct for the Iceriver KS0, KS0 Pro, KS0 Ultra, AL0 and RX0 miners is designed for mounting an external 120mm fan to lower operating temperatures in devices that are significantly overclocked.

To install, the side panel is replaced. 

Optionally, a single air duct can be mounted on one side to blow fresh, cool air into the case, while the panel on the opposite side should be removed or replaced with a grille. Alternatively, two air ducts can be mounted for air intake and exhaust. Depending on the choice of external fan, it can either be connected via the miner's USB port or, for high-airflow fans (usually 12V), through an external power supply.

Although the KS0 has a different side panel design compared to the others, the basic layout is the same, allowing this air duct to fit all the listed devices. The air duct also features an opening through which the power supply or Ethernet cable can be routed. 

For easier mounting, four M3x10mm screws are recommended instead of the countersunk screws that secure the side panel.

Printed with:

  • eSUN ABS+ Black
  • @270°C
  • 0.3mm layer hight
  • 0.6mm nozzle
  • on Bambu Lab P1P (+ enclosure)

Tagi