Adjustable Lego Compatible Monitor Shelf - Fits most monitors
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small shelf that rests on top of your monitor to snap your favorite pieces to.
- Ocena
- 5 / 5
- Polubienia
- 67
- Pobrania
- 282
- Wydruki
- 1
- Wyświetlenia
- 2570
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Share Alike
An adjustable shelf that sits on top of your monitor to put your favorite Lego mini figs on display. Fits on my curved and flat monitors and looks great.
Need to print the Shelf and Support Arm. Support Arm can is adjusted to fit your monitor and remain flat.
If you like the shelf but don't care about displaying your mini figs, check out the original Adjustable Monitor Shelf over on GiskardReventlov's page.
Print Settings I used below. I did multiple tests with different sized studs, settings and positions. This yielded the best results for my Neptune 4 Pro and tolerances.
- Support Material Required
- 0.2mm Layer Height for most of the print
- Used Height Range Modifier for 19.8mm - 21.8mm
- Changed to 0.08mm layer height
- This includes the top most layer of the base plate as well as the studs
- Iron top most surface with concentric lines to smooth the top leaving the smallest defect in the center of the stud
- Seam wipe before external loop
- Wall printing order Inner/Outer/Inner to ensure outside lines were as close to perfect as I could get
UPDATE - Created 4 stud sizes from 4.75mm to 4.9mm studs (Standard stud is 4.8mm).
I recommend you download all 4 tolerance testers and print with the settings you will use for your final product. Then tweak print settings for your best fit. You may want to print your best fit with a few different settings to find the perfect fit. Each tester is only about 1g of filament, worth the extra tests in my opinion.