Base Stabilizer for SUNLU FilaDryer S1 - Filament Dryer Accessory

Introducing the ultimate base stabilizer for your SUNLU filament dyer!

Designed with the precision of a cat owner tired of feline-induced chaos! Say goodbye to precarious perching and hello to purr-fect stability. With this base stabilizer, even your most mischievous moggy won't stand a chance at toppling your precious equipment.

It's the cat's meow of filament drying accessories for your filament dyer!

Print settings

I recommend minimum layer height of 0.30 mm (Draft Mode) if you don't care about the quality of the print and want to print this quickly. The functionality will remain the same even if you print it with a lower resolution.

A fill density of minimum 10% with Gyroid fill pattern works well. 

Print with 3-4 perimeters for extra strength.

You may need to disable the skirt to make it fit on the plate.

To achieve optimal results I recommend to set your printer to 7x7 mesh bed leveling (MK3S+) which can be found within Settings - Mesh bed Leveling, on the LCD menu.

Supports and Brim are not required.

Add some rubber feet at the base to prevent sliding.

Enjoy!

3D Model Usage Disclaimer

All 3D models provided by me are offered free of charge and are licensed under a Creative Commons license. These models are intended for personal and non-commercial use only. Resale, redistribution for profit, or inclusion in any paid product or service is strictly prohibited.

Any unauthorized commercial use or sale of my models constitutes a violation of the license terms and may result in a formal report, takedown request, and potential legal action. By downloading or using these models, you agree to comply fully with the stated licensing conditions.