FormD T1 Exhaust shroud enhanced compatibility

During my continuous search to improve the FormD T1s cooling, I found the fan shroud from eiga. It was too long for my and many other printers though, so I remixed it.

First I needed to split up the part into two smaller ones, that are easier to print even on smaller printers, like a Prusa Mini for example. But this created the challenge of the mounting rails being kinda unstable, because they of course also needed to be split.

I then removed the mounting rails entirely and added two alternatives instead:

Pre-Supported Version

Added a Pre-Supported file with easy to break off supports for printing on 230x150x220 sized printers (minimum). Enable brim and print best with PLA and lots of cooling for clean overhangs.

Version A

This version has some small cutouts, that are designed to fit the Quiet Fan Brackets from Greymanx or my own remix (for FormD T1 V2.5) of them.

Best add some small tree supports like shown in the screenshot.

Version B

This is the part with just the mounting rails removed and being split up into two. You can use the standard fan mounting rails, that come with the case.

Have fun printing!