A super simple magnetic white board marker holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I needed a marker holder in my home office and designed and printed this while on conference calls.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 226
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
It's not much to look at, but it works perfectly. I had a need, I solved that need.
It takes 8x3mm neodymium magnets in the back to stick to magnetized whiteboards. I made the slots for the markers a little wide so they can accommodate multiple sizes if need be.
For my print, I took the default “0.20mm SPEED” print settings in PrusaSlicer and just bumped up the layer height to 0.3mm. I printed it using 10% gyroid infill, and it is plenty rigid and strong enough to hold the lightweight markers.
The line you see in the middle of the print in the photo is because I had the holder upright on the build plate, and I ran out of filament mid-print. I have no idea why it looks so different, given it's the same filament from the same company. It's a marker holder in my office, so I didn't care enough to reprint it.