Creality K1 Max Side Braces
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Side braces for the K1 Max (version 1.2 alpha)
- Ocena
- 0 / 5
- Polubienia
- 49
- Pobrania
- 229
- Wydruki
- 0
- Wyświetlenia
- 2174
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Version 1.2 (alpha)
Re-install using M3x18 screws - do not use too long of screws as they can hit the belt or corner blocks.
If printing in ABS you MUST use 99.5% shrinkage setting in Orca (or similar) for the filament setting.
Printed with 5 walls and 20% gyroid infill these were about 85g of filament for each corner
Kudos to D3D for the original design. I built a digital replica of the side panel and laid it over the K1 side brace and extended the model/re-created the screw holes to fit.
This has been test fit on my K1 Max with success. Please do a test print first using just a few layers to verify fitment based on shrinkage settings.
Changelog:
Version 1.0 : Uploaded initial model
Version 1.1 : Removed recessed holes from top/bottom center screw location (K1 does not have a screw here so on the K1 the pieces just bolted together)
Version 1.2 : Increased height of lower left/lower right pieces by .1mm, decreased width of top left piece by .05mm