Creality K1 Max Side Braces
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Side braces for the K1 Max (version 1.2 alpha)
- Rating
- 0 / 5
- Likes
- 49
- Downloads
- 229
- Makes
- 0
- Views
- 2,174
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Version 1.2 (alpha)
Re-install using M3x18 screws - do not use too long of screws as they can hit the belt or corner blocks.
If printing in ABS you MUST use 99.5% shrinkage setting in Orca (or similar) for the filament setting.
Printed with 5 walls and 20% gyroid infill these were about 85g of filament for each corner
Kudos to D3D for the original design. I built a digital replica of the side panel and laid it over the K1 side brace and extended the model/re-created the screw holes to fit.
This has been test fit on my K1 Max with success. Please do a test print first using just a few layers to verify fitment based on shrinkage settings.
Changelog:
Version 1.0 : Uploaded initial model
Version 1.1 : Removed recessed holes from top/bottom center screw location (K1 does not have a screw here so on the K1 the pieces just bolted together)
Version 1.2 : Increased height of lower left/lower right pieces by .1mm, decreased width of top left piece by .05mm