Ikea OBSERVATOR Bracket for Closetmaid Wire Shelving
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This bracket was designed to allow an Ikea OBSERVATÖR wire basket to be attached to a ClosetMaid Close Mesh Wire Shelf.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 40
- Wydruki
- 0
- Wyświetlenia
- 1147
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
This bracket was designed to allow an Ikea OBSERVATÖR wire basket to be attached to a ClosetMaid Close Mesh Wire Shelf. These baskets can be had for around $3 USD, which is a bit cheaper than the ClosetMaid version of these baskets.
Feel free to leave a comment if you feel the design could be improved, or remix the file yourself.
Assembly:
Start by hanging the two "fingers" of the basket on the ClosetMaid shelf. Then snap the top part of the bracket to the ClosetMaid wire shelf. While supporting the basket, the bracket can be slid on the ClosetMaid shelving towards the Ikea basket and attached to it.
More than two brackets could be used to better support the basket.
Print instructions
Category: Organization Print Settings
Resolution: 0.2mm
Notes:
Print the part in the orientation it is downloaded in, to ensure proper fit. Best to print at a layer height that will provide good layer adhesion, as the bottom portion of the bracket is relying on this for support.