Streamlight survivor replacement lens bezel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement for the lens bezel of the Streamlight survivor flashlight commonly used by firefighters.
- Ocena
- 5 / 5
- Polubienia
- 38
- Pobrania
- 336
- Wydruki
- 1
- Wyświetlenia
- 1313
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution
The original lens bezel is prone to break if tightened a bit to hard. This usually happens if the lens does not snap into place and you don't notice it while tightening.
In the original bezel there is a small groove for a rubber o-ring, which is not present in the replacement part i've used from thingiverse. Instead of adding it to the model, i've tried to print it with eSUN eTPU-95A which turned out great.
With my printing settings for that filament there is a bit of stringing and some blobs around the edges, but with a proper heat gun or a simple lighter these can easily be removed.
If you have better print settings, please share them with me, i would be happy to see improvements in the print quality.
The model fits perfectly to the flashlight and with the TPU used i don't worry about the missing o-ring. I'm less worried that this part may break this easily in the future.
The lens protector snaps right into place, you can just re-use it. Or as the original creator of this file mentioned, you can create your own replacement:
If you need to replace the lens as well it is a 52x1 mm clear lens. A possible source for this is recycling a CD Jewel Case.