Streamlight survivor replacement lens bezel
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement for the lens bezel of the Streamlight survivor flashlight commonly used by firefighters.
- Rating
- 5 / 5
- Likes
- 38
- Downloads
- 336
- Makes
- 1
- Views
- 1,313
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution
The original lens bezel is prone to break if tightened a bit to hard. This usually happens if the lens does not snap into place and you don't notice it while tightening.
In the original bezel there is a small groove for a rubber o-ring, which is not present in the replacement part i've used from thingiverse. Instead of adding it to the model, i've tried to print it with eSUN eTPU-95A which turned out great.
With my printing settings for that filament there is a bit of stringing and some blobs around the edges, but with a proper heat gun or a simple lighter these can easily be removed.
If you have better print settings, please share them with me, i would be happy to see improvements in the print quality.
The model fits perfectly to the flashlight and with the TPU used i don't worry about the missing o-ring. I'm less worried that this part may break this easily in the future.
The lens protector snaps right into place, you can just re-use it. Or as the original creator of this file mentioned, you can create your own replacement:
If you need to replace the lens as well it is a 52x1 mm clear lens. A possible source for this is recycling a CD Jewel Case.