Testbed for N20 motors and robotics projects
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
As the title says, has 5mm hole pattern with 8mm spacing to fit whatever you want, with screws, dowels or zipties.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 467
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
A simple 150mm x 120mm slab of PLA meant as a testbed for electronics and motors, has a 5mm hole pattern with 8mm spacing, which can be used to mount things (batteries, servos, whatever you want) via screws, dowels or zipties.
The N20 motors are mounted via small zipties in small little recesses. Those _can_ be slightly to large or to big depending on the gear ratio of the N20 motors. If needed, extrude the recess a bit more.
Step file is included.
Print Settings:
- perimeters and top/bottom layers don't matter to much, increase their numbers to make it a bit more robust
- no support needed
- no post processing needed
The big wheels seen in the picture can be found here.