Small drawer slide bumper for full extension rails
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Recreated to fit my specific, smaller, model of drawer slides used in an Amish chest of drawers.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 161
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Share Alike
Print in TPU
Use .2mm layer height
Use 10% infill - enough to add a little structure but still want it to be somewhat squishy - I printed in 95A hardness (which is pretty stiff, squishier TPU may need a little more structure, but anything from 0%-10% is good for basic TPU). I just printed a set of these with 0% infill and they work just fine, they have a little more "give" so if a drawer slide is a little sticky they won't bend the metal ear they sit over.
NOTE: Use a TPU specific profile to slow down printing an appropriate amount. Also, Printing with 1 perimeter will make this feel much ‘squishier’ but it may not hold up as long. I've found that either 2 or 1 perimeters or walls are functional but 2 may hold up longer.
NOTE:
My model was *not* remixed, it was inspired by this other thingiverse object and I want to give some credit: https://www.thingiverse.com/thing:5258887
I modeled this from scratch in Fusion 360 because the drawer slide stops I require for our Amish oak drawers were smaller and the shame needed to be different. Lastly, I wanted to try and build it using parameters so I can resize easier in the future. While this, technically, is *not* remixed, it is inspired from the work done by this person - thank you!