BottleBubbler

MOUTHPIECE: threads on to any standard pop bottle (0.13 ISO Standard Thread Pitch). The adapter houses a 14mm bong downstem into {insert pop bottle – glass bottle}. This allows for the bowl to be in contact with the downstem rather than plastic. There is also an anti-splash percolator before the mouthpiece. It has a threaded bottom to allow for easy access to drain/clean. *If threads are tight, you can print at 99% scale OR sand the sides of the threads a little with 400grit.*

***48mm 400CT 4oz MASON JAR BONG CHAD MODE***

MASON JAR BASE : holds a ~52mm wide 4oz mason jar. (I found a pack of four at the dollar store). 

I believe these are the same here: https://www.berlinpackaging.com/ball-4-oz-clear-glass-mini-storage-mason-jar-6793b01/

MASON JAR TO POP BOTTLE – MOUTHPIECE ADAPTER: This adapter allows you to screw on to a 4oz 48-400CT Mason Jar (Optional but recommended: Use with the TPU Outer/Inner Gaskets). Once mounted to the mason jar, the mouthpiece now mounts to the top.

ASHCATCHER : 14mm Male  - 19mm Inner. (I intended the use of a 14mm Male -→ 18mm Glass stepdown [https://www.amazon.ca/Ciieeo-Female-Essential-Adapter-Compact/dp/B0B62H3CGJ/ref=sr_1_1_sspa?sr=8-1-spons&sp_csd=d2lkZ2V0TmFtZT1zcF9hdGY&psc=1])

The top of the ash catcher is shaped like a tray to catch stray bits when loading your bowl.

14MM MALE TO 14MM FEMALE STEPDOWN : Probably shouldn't be using your bowl straight out of this – I would recommend sandwiching it between glass.

Sand down the 14mm/18mm Male/Female ends to ensure tight fit.