PRINTER AMBIENT AND ENCLOSURE MONITORING STATION (ESP32 w/ BM280)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This my ambient and enclosure monitoring station based on Adafruit Feather ESP32 and BME280 sensors.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 402
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is my ambient monitoring station box for my PRUSA MK4.
The project is based on the Adafruit Feather ESP32 with BME sensor (P/N 5303) that will measure the outside ambient temperature, pressure and humidity. Inside the enclosure is another BME280(P/N 2652) module and one oled display (P/N 5297) shows all the relevant info.
I will not cover in detail or share for now the software loaded on the ESP32, but in short resume the working philosophy is as fallows:
The ESP boots up, connects to my home wi-fi, logs into influxDB and transmits both onbaord and esternal BME sensor data, as well the Wi-Fi signal details. The data is also shown on the oled display and aceesible via Grafana on a Home Assitant page still in development. After the data tranmoited the ESP32 is put to sleep for 5 minutes, when the this times elapses the sequence described above is repeated.
The reason why I setup the sleep mode, is mainly to prevent the ESP32 baord to heatup and afecting the onbaord BME280 sensor.
Although is alrady runinng, the code still needs some tweeks and sometimes the oled display does not show info. Also still need to fine tune all the reboot conditions in case conencion is not achieved causing the system to hang.
Nevertheless, the hardawre is done and can be adapted to other projects indepent of the code on the ESP32, so find it to be interesting to share it.