1 / 2
Lubricant LM8UU adaptor for Super Synco Lube DE21030 with screw cap — zdjęcie 1
1 / 2

Lubricant LM8UU adaptor for Super Synco Lube DE21030 with screw cap

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Lubricant LM8UU adaptor for 85g Super Synco Lube DE21030 tube with cap.

Ocena
5 / 5
Polubienia
212
Pobrania
1320
Wydruki
53
Wyświetlenia
4737
Oceny
49

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Purpose:

Tool for lubricating LM8UU bearings with a 85g tube Super Synco Lube DE21030 synthetic grease and a screw cap.

Are you looking for the same tool with screw cap for the original prusa grease tube? Look here: https://www.prusaprinters.org/de/prints/120081-prusa-lubricant-lm8uu-adaptor-with-screw-cap

If you need the same tool for 10mm bearings in normal and long length, you can find it here: https://www.printables.com/de/model/712337-lubricant-lm10uu-and-lm10luu-adaptor-for-super-syn

 

Update from 2024-01-19:

Added a second version on demand.

Version 1 is stil the old one with small bore holes.

Version 2 has short slots. This means that less pressure has to be exerted on the tube when lubricating the bearing.

 

References:

This is a remix based on the LM8UU adaptor from David Honza.

https://www.prusaprinters.org/de/prints/32359-prusa-lubricant-lm8uu-adaptor-bearing-pacifier

and

the base and the screw cap for the superlube tube from ri3del.

https://www.thingiverse.com/thing:3678611

I tried to link the model from ri3del with the official remix link, but it doesn't work. For this reason both references are listed on this position.

I combined the needle with the base and modified slightly the inner thread of the injector for a better fit on the tube. 

 

Handling Instruction from David Honza:

Remove all thin strings before first use!

Screw the printed tool on the Prusa Lubricant tube, carefully put the bearing on and turn it counterclockwise until you feel a slight resistance. Then press the tube and watch the tip of the tool for grease leak. Once the grease starts leaking, the bearing is lubricated sufficiently. 

 

Used print settings:

Material: PLA.

Resolution: 0,1mm

Infill: 25%

Perimeters: 2

Brim: no, maybe required when bed adhesion is not the best

Support: no 

 

Tagi