1 / 6
LED Light Bar Headrail Bracket
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A bracket for attaching an LED light bar oriented at 45º to a headrail (or any rectangular cross section).
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 323
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I use two of these brackets to mount a LIFX Z LED light strip inside of an aluminum channel to a headrail to orient the light at 45º for reading in bed.
Models included:
- Print at least one of these
- Bracket without a wire channel
- Print one of these depending on the end you'll attach the wire
- Bracket with a wire channel on the left
- Bracket with a wire channel on the right
I've included the Fusion 360 (.f3d) file. You can easily change the user parameters for the headrail width (currently 71 mm + 2*PrinterTolerance), height (25.2 mm + 2*PrinterTolerance) and wire channel diameter (3.5 mm).
Print instructions
- Orientation and Supports
- Bracket - Lay down on either side. Supports not required
- Wire Channel - Orient the wire channel upwards and support the wire channel. Be very careful and go slow removing these supports.
- Layer Height - 0.20mm
- Material - PLA
- Perimeters - 3
- Infill - 15% Gyroid