1 / 6
LED Light Bar Headrail Bracket
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A bracket for attaching an LED light bar oriented at 45º to a headrail (or any rectangular cross section).
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 21
- Makes
- 0
- Views
- 323
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bedroom
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I use two of these brackets to mount a LIFX Z LED light strip inside of an aluminum channel to a headrail to orient the light at 45º for reading in bed.
Models included:
- Print at least one of these
- Bracket without a wire channel
- Print one of these depending on the end you'll attach the wire
- Bracket with a wire channel on the left
- Bracket with a wire channel on the right
I've included the Fusion 360 (.f3d) file. You can easily change the user parameters for the headrail width (currently 71 mm + 2*PrinterTolerance), height (25.2 mm + 2*PrinterTolerance) and wire channel diameter (3.5 mm).
Print instructions
- Orientation and Supports
- Bracket - Lay down on either side. Supports not required
- Wire Channel - Orient the wire channel upwards and support the wire channel. Be very careful and go slow removing these supports.
- Layer Height - 0.20mm
- Material - PLA
- Perimeters - 3
- Infill - 15% Gyroid