1 / 3
Voron 0 /0.1 Mini Afterburner mod of the Revo Voron hotend to use a 30x30x10 Fan. — zdjęcie 1
1 / 3

Voron 0 /0.1 Mini Afterburner mod of the Revo Voron hotend to use a 30x30x10 Fan.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Voron 0 /0.1 Mini Afterburner mod of the Revo Voron hotend to use a 30x30x10 Fan.

Ocena
0 / 5
Polubienia
4
Pobrania
38
Wydruki
0
Wyświetlenia
735
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v3.0

Voron 0 /0.1 Mini Afterburner mod of the Revo Voron hotend to use a 30x30x10 Fan.

I am looking to update my Voron 0.1 to a new Sherpa Mini base extruder the next time I do maintenance. 

I had a 30x30x7mm fan failure after about a month of use from my Voron kit. It was difficult to source a replacement 30x30x7 in a timely fashion. However I did have a bunch of stock fans from E3D V6 which were all 30x30x10mm in either 12 or 24V.

From the Mini-AfterSherpa (including instructions)

https://github.com/PrintersForAnts/Mini-AfterSherpa

Using Fusion 360 the CAD model from the above project was used:

-MiniAS_Revo_Voron_Base.step

-30X30X7 DC fan -1 (from original Voron Afterburner model)

I was able to use the fan as a template and extrude the opening, and then open the fan hole to 30.2mm to allow enough clearance for the fan. I tested with a couple Raspberry Pi fans, and the E3D fans I had, and their dimensions were between 29.89 and 30.02mm. These were able to be insert in and out with minimum effort.

30x30x7mm also worked in my test fitting, this could allow for custom fan shrouds.

Requirements:

2 x M3x15mm screws to mount fan

**2 x M3x20mm if using the ADXL345 mount through the fan found here:

https://www.printables.com/model/124728-voron-v0-mount-for-adxl345

Print Settings:

-use same walls/perimeters, and tops/bottoms as stock Voron parts

**with exception add support touching bed

Install

-Remove support material over the mounting holes. Small pin may be required to knock out the material in the holes

-place fan in through the opening use the same orientation from instructions of Voron manual for cable management

-use M3x15mm screws to mount fan (I used course threads in my build)

Notes

**Okay so I had some of this sketched from my previous project to make my life easier.

https://www.printables.com/model/238034-voron-0-mini-afterburner-cowling-dragon-30x30x10-f

**ProtoXtruder is being used for my extruder upgrade found here:

https://www.printables.com/model/436425-protoxtruder

Tagi