Liczymy pasujące modele…
I wanted to dry silica gel packets in my Eibos Cyclopes filament dryer so I designed this simple drying rack to fit inside and stack so there's two layers. There's room for a third layer, if required. I printed it in ASA so it would…
Allows headphones or a headset to be mounted anywhere on either top side of the Corsair 5000D Airflow case. No mounting hardware required - kept in place by the removable top vent cover. Just pop up one side of the vent cover to put in…
Confirmed as working with the Logitech K120. It may work with other models but not tested - it's 15mm wide. Ideally print with supports for the hinge pins. PLA is probably sufficient but PETG or greater is recommended.
PETG suggested for long-term durability but PLA (ideally +/Pro) will probably suffice. With PETG, I found the bridging over the bottom channel was a bit rough and it affected how well it fits on the rim of the tin can. Perhaps scaling up…
PETG suggested if chemicals are going to be sprayed onto the floor when they're in place, otherwise PLA will suffice.
Rear cable guide channels can direct the cable left, straight back, or right. Two M4*16 screws and two M4 hexagonal nuts required. Supports not required but can be enabled for the cable channels underneath.
This is a first attempt at making a tissue box cover, prompted by a Printables competition. The design is inspired by the beer crate battery holders. The picture is currently of my first printing attempt in PETG on the Bambu Lab X1…
Printing out of hard TPU recommended for robustness, impact resistance and to avoid scratching - had good results with 98A but standard 95A would probably work. Originally designed to have a soft TPE grip ring, but I found it quickly got…
PETG suggested if chemicals are going to be sprayed onto the floor when they're in place, otherwise PLA will suffice. A striped effect, which may also help with grip, can be applied in the slicer by applying two height modifiers with…
Designed to fit loosely on a 41mm (outer top diameter) plastic supermarket shot glass. Print upside down, with the point of the funnel pointing up. No supports required. Ideally print in a bright colour, such as yellow or orange, to help…
Handle variants help with sliding on a surface to pick up or rotate. Non-handle version is still adequately accessible and manoeuvrable, and fits within the footprint of a full tray (handles stick out of the footprint by a couple of…
Printed in two parts to avoid excessive supports. Parts fit together with a snap fit. There is a 0.1mm gap between them - test fit parts are available to test before printing the whole thing. 10mm, 20mm and 30mm outer walls available…
Requires orienting in slicer (options pictured) and a slight cut made to get a flat surface to print from. May also need to be mirrored in slicer depending on which side needs replacing. Supports required. ABS/ASA/TPU suggested. PETG may…
To wszystkie aktualnie dostępne wyniki.
