Liczymy pasujące modele…
Made to hold a door closed, so hook is set at 90 degrees. I may upload a 180 version later for something like a trunk lid that needs hook and latch to be parallel. Also hook only has the 2 screws, restricted by my use case. If you're…
I'm hoping to find/make some tool holders and stuff for my K1. Obviously this riser is limited in which connectors you can use, since its too short for any vertically stacked pieces. Almost worth stretching the corners of the riser to fit…
Another take on the over-center latch I needed for a specific door in a conversion van. This door has a corner I needed to get around, so it's designed for that specific spacing. I can change that a little, so if this is close to what you…
Needed burly plugs for the spare wheel pan and other undercarriage holes of my mk4 golf tdi. In the spare wheel pan, the original ones were installed from above, so I made them similar. I wanted the flange that goes through the hole to…
I have spool rollers that fit in the ceeal boxes, so I made a bulkhead to feed filament right out the pour spout, without cutting any holes.
To wszystkie aktualnie dostępne wyniki.
