Liczymy pasujące modele…
This is a remix as mentioned in the summary. I made this for a friends birthday and modified it to fit a standard 32x8 LED Matrix from Amazon. The modified files are the ear cups (threaded and hollowed to house electronics) and the front…
Designed this for my 3mm Acrylic door for my printer enclosure. The fittings are friction fitted and so your results may vary depending on the accuracy of your printer. If the top hinges are not tight enough and slip out it will break the…
My dad needed a spark plug holder for the race engine so he could inspect them when rebuilding. This is designed to hold 8 NGK plugs, it also has an optional magnet insert where you can pause the print of the base and insert 8x 10x3mm…
I have a cheap AOC monitor that uses a pillar into the stand to hold itself up, and has no VESA mounts. I am not wanting to replace it just yet so this is a solution to that problem. You will want to have good layer adhesion to print it…
Designed a cover for the RJ45 Jack. Uses the geometry of the plug to hold it against the port nice and flush, however if your port is inset it will not work and you will need to edit the file to lower the bottom tab that the plug pushes…
Print as is, no supports needed, mount with command velcro strips
I use my ROG Ally in docked mode often and this enables it to be securely mounted to the wall and plugged into my dock setup that I have for it. It has some slits for the speakers and I used some sticky foam to place on the inside to…
A remix of the iPhone 14 phone holder
Modified AmicoJeko's model to thicken the base slightly to fit command velcro strips rather than the standard strips that would leave an exposed pull tab. The velcro ones can be completely invisible. The strips I used are 20mm wide and…
This is a remix of gunnarholm's design over on thingiverse. Its designed to replace the existing Nissan Leaf speakers with aftermarket 6 ½" drivers. I split this one in two so it would fit on my prusa mini and it prints with no supports…
This uses velcro command strips to mount these cute little Lego plants to the wall. I printed them on their side with organic supports on each Lego style post so they maintain their shape and fit well with the Lego base of the plants. You…
This is a really simple print that uses some mid print M3 Nuts and two 10mm M3 bolts to firmly secure “The Milky Way” Lego set to the wall. Most of the weight is held by the main body of the print where it juts out, distributing the…
Holds a 3mm acrylic door closed in my enclosure, print in the orientation the files come as for maximum strength as the plastic needs to bend when it closes shut. I used Prusament PLA and it has held up fine. I would suggest gluing them…
Changed the model up a bit so I could screw it into the shelve plywood, you will need supports.
I am a big fan of the ‘One Line a Day’ (OLAD) journals and have already completed one. I also travel often and take mine with me. After seeing the wear on my older original I wanted to make a protective cover, that would also store my…
This is designed to go around the head rest pegs in the back seat and hold a folded up sun reflector that you would place in your windshield. I made this so it wasn't moving around in the boot all the time. I printed in PLA but PETG is…
These are some legs that I originally designed to secure my subwoofer box in the back of my car. There is M3 nut and bolt inserts so that the legs themselves can slide onto floor mounted rails and then be screwed into place. This design…
To wszystkie aktualnie dostępne wyniki.
