Liczymy pasujące modele…
986 GT3 Center Console Delete The split file is to fit on a Prusa Mk3s Recommend using PETG Must remove orange tabs on the bracket to mount Left enough room to upholster part Fit as one part on Prusa XL. Used PETG with organic supports.…
Added the front OEM chin spoiler and got rid of one of the headlights since this side profile isn't supposed to have any 3D perspective to it.
I printed this on my PrusaXL diagonally with PETG. The photos are of a special one I made for a friend with a name, my file here does NOT contain the name.
**FIXED Shoei NXR2/RF-1400 GoPro Chin Mount by Masway1400 on Thingiverse: https://www.thingiverse.com/thing:6272613 Summary: Fixed the gap between the rails and the body of the mount so that it prints like a continuous body.When slicing…
Previous one i found had my camera tilted down too far. so i added a 3 degree and 5 degree angle increase versions. You can flip the old version to get a better angle but then the chin vent wont open properly/at all. I also flattened the…
This is the top portion of a spacemouse from 3dconnexion. It has a rubber coating that over time breaks down and becomes sticky and gross. Simply pop the top cap off yours, unscrew the 3 screws, remove the old top knob, and slide this one…
OK, so after increasing the angle by 3° and then 5°, it was apparent that some people might still need MOAR! so I did 8° and i tightened up the clasp area for the slide in gopro mount so it would not rattle at all. use some 3M VHB tape…
After printing two other models I found online that didnt fit my 2016 ktm 500 EXC, I designed this from scratch. Works perfectly, protected by headlight mask, easy to view, still can see OEM signal light, room for key relocation, uses…
To wszystkie aktualnie dostępne wyniki.
