Liczymy pasujące modele…
I also added a small plug that goes over the bolt head that eliminates the possibility of shorting if the bolt were to come loose against an earthed chassis. I heated up a torx driver and melted a small star into the plug to hold it in.…
This mudguard integrates 3x5mm LEDs to make a tail light. You'll need some soldering and electronic skills. The LEDs were soldered together in series and then potted in hot glue. The LEDs I used are rated at 2.1v for 35,000 mcd (link…
I wanted some horizontal rod storage for inside my boat but one of my rod butts didn't fit in at least one of the commercially available rod holders. This is a parametric model (Fusion 360) that allows you to specify spacing distance (to…
So if I had my time again I wouldn't bother doing this - I'd just pay the money for the stupid proprietary Briggs and Stratton Instart battery. But once I started I was kinda committed… This project is probably of quite niche appeal, even…
As per the title, elevates the Cerbo unit to provide space underneath to pass cables through, saving space and providing a meater layout. Most materials woud probably be ok, except PLA as it may get warm depending on your setup. Best…
Oxford Hot Grips are great, but the mount supplied with them is crap. This one mounts to a 31.8mm handlebar with a zip tie. The Oxford heated grip controller is screwed to the mount. Pics show it installed between the bar clamps of my…
I made this very simple dock to mount the Inreach Mini 2 to the dash of my truck. It slides in (friction fit) and stays put. Printed in ASA for heat and UV resistance on the dash.
I made this to fix to the inside of my boat. It holds a regular filleting knife, maximum blade width about 21mm. Holes drain moisture to prevent rust and reduce filament requirement. I printed it in ASA for UV resistance. PETG would…
The problem with the Surface Pro and other tablet based 2 in 1 PCs is that they aren't very nice to use in your lap. The rear kickstand/wobbly keyboard attachment etc make it unstable except on large hard surfaces. Microsofts absolutely…
This little widget pops into your crank bolt (assuming it has an 8mm hex) and features a slot on the outside for your tape measure to bite into. It helps you get a highly precise measurement of seat height (in combination with something…
I made this to use with my Minisforum V3. The perennial problem with all 2 in 1 type tablets is that they suck to use in your lap - this aims to fix that issue. It is a full keyboard, and the trackpoint allows full mouse functionality. I…
Simple mount for a frame/wheel lock to suit a Larry vs Harry Bullitt. May suit other bikes with similar seat stays. Print two copies, uses M4 screws and nuts and a few zip ties. There are internal channels for the zip ties, ensure…
I relocated the dash gauge on my XSR900 that left some exposed bolt holes. I used them to mount this dash panel to that has room for a small momentary on switch (8mm in diameter, secured with a 10mm hex nut) that is wired to a garage door…
I seem to rest my finger on the top bezel of the Kindle, and my new Paperwhite 12th gen has such a thin bezel that I'm always triggering something on the touch screen. This grip/bezel extension thing solves that. It's got a few little…
To wszystkie aktualnie dostępne wyniki.
