Liczymy pasujące modele…
Waveshare RGB Panel Wall Mounting System Hang your Waveshare RGB matrix panel on the wall in about two minutes, with nothing showing from the front. No supports. SCAD files. These panels mount on little magnetic risers that screw into the…
Zero-Play Tapping Arm A remix of Muffelkraft's Improved Tapping Arm with a guide that actually holds the tap holder square. No wobble, no supports. I liked the Improved Tapping Arm, but my 12 mm tap holder rattled around in it. The…
A base plate for an air hockey paddle (mallet) whose felt bottom has come off due to lack of a baseplate supporting it. Mine lost its felt, and it turned out the paddle is hollow underneath. This plate closes it up and gives it a flat…
A printed insert for the Lee Valley drill press table and fence . It's meant to be sacrificial: print it in cheap PLA and replace it whenever it gets chewed up. Two versions With hole: a 26 mm hole for the bit, off-center (its center is…
A holder for standard Hot Wheels track connectors . Drop connectors in from the top and they stack up inside. The front is open most of the way across, so you can see how many are left and reach in for one. Holds about 25 standard…
Five little spools of enameled wire, loose in a drawer, will find a way to roll around and unwind into one tangle. This is a case for them: one spool in use, four waiting, and a front plate that keeps everything where you put it. Which…
A drawer holder for a pair of 3/8" drive adjustable tap sockets. Both sockets stand upright, square drive down, and a slide-in plaque on the front says which taps each one takes. Which sockets It's made for these two sets: Irwin Hanson…
A case with a sliding lid for the 5-piece long drive pin punch set that's sold by Harbor Freight (and under other names on Amazon and elsewhere). The punches lie side by side in fitted pockets, and the lid slides in on a dovetail and…
A lever handle for a Schlage-style house key. The key's head is glued into a slot at the bottom of the handle, and the handle steps up and out to one side, so you turn the key with a lever about 82 mm long instead of pinching its head.…
A holder that keeps air hockey pucks on the table, so they don't wander off between games. It screws flat to the side of a table leg with the open side up, and the pucks drop in on edge. Mount one on each side of the table and each player…
A small US Constitution for a board game my son made up: an ivory page with "We the People" raised in black script across the top. Posting it in case anyone else has a use for it. Needs a fine nozzle The script has very thin strokes, many…
A flush mount for the Ring Solar Pathlight . The light normally sits on a stake pushed into the ground; this lets you mount it on a deck, a step or any other flat surface instead. The light's tube locks onto the collar the same way it…
A door handle I designed for our Producer's Pride Chateau Coop from Tractor Supply (SKU 2015286). The handle is two grips, one on each side of the door. Their square stubs pass through the chicken wire and meet in the middle, and two…
A case for three brad point bits, with a sliding dovetail lid that clicks shut. It holds the 5, 6 and 8 mm bits, which are the sizes for fischer DuoPower wall anchors. Each pocket is only as long as its own bit, so the case stays small:…
To wszystkie aktualnie dostępne wyniki.
