Liczymy pasujące modele…
In addition to the printed parts, 2 cylinder head screws M3x20 and 2 magnets Ø6x3mm are required. Assembly: Mark the two magnets at the point of contact with each other. Put the mounting device on the edge of one half, insert a magnet…
This Clothes Hanger very stable
Holder After printing remove the support, melt in the threaded inserts M3 (2 pcs.) and press in the magnets Ø6x3 (8 pcs.). The height stop is bent 90° and snaps into place (see picture) Camera mount Remove the support, drill out the holes…
To determine whether the insert fits into the refrigerator, measure the underside of the basket. The length is 335mm. The width is trapezoidal. It is 220mm wide at the front and 210mm at the back. Um festzustellen, ob der Einsatz in den…
Instructions: In the default setting, only the “Merry Christmas” label is activated. If the inside or backside is to be activated, the respective extruder for backside or inside must be changed to extruder 1 in the slicer settings. The…
To use the smartphone in the cradle, the slider is actuated against spring pressure (red) and released after inserting the smartphone; it sits firmly in the cradle. After some time of use, the slider became increasingly stiff until it…
These two parts are connected with 2 Spax screws 3.5x16mm screws (or similar), but can also be glued together. Then choose the right position on the wardrobe, turn the holder upwards by approx. 30° and press it down until it is horizontal…
To wszystkie aktualnie dostępne wyniki.
