Liczymy pasujące modele…
Click together hexagon LED lamp. Perfect for garage, homegym, workshop or similar. There is room for wiring underneath the individual segments and holes in the corner pieces to feed the wires to the led strips. I am using 12v natural…
Sturdy shelves for acoustic panels - non destructive - with cheap IKEA glass shelf. I needed some shelves for my acoustic wall panels that would not destroy the wood panels in any way. These are screwless mounted to the wall panels. The…
Pimp your bike with these custom designed mudguards. Fits both front and back. Attach with Zipties. There is a plain version (stl) which is single color. I also included Fox and RockShox multicolor versions. I have printet them on a…
Very minimalistic enclosure and stand for BitAxe Gamma 601. Well ventilated and good for overclocking. M3 heat inserts are used for the fan casing that is attached to the enclosure. M2 heat inserts are used for the enclosure to fixate the…
Remix of the original EBB42 vertical toolboard mount for LDO Orbitool O2 toolboard. It will fit both V-Core4 and V-Core3 toolhead. Instead of a pianowire there is a hole for a piece of nylon filament. The step file is included so it is…
Double Helix LED lamp controlled by ESP32 and WLED Each Helix and the base has individual controlled WS2812B (144/m) led strips. I have included the upper base as step file so that it is possible to add mounting points for an ESP32. The…
I only needed one w1209 in my IKEA Lack enclosure to control my venting fan, so I made this remix of Hugos awesome design. I also included the probe holder files for easy access to both designs.
If you want to replace the dated Creality Touchscreen on the Sermoon D1, and also replace the firmware with something that actually works, then this mod is for you. The original screen has been replaced with BigTreeTech TFT5 v2.1, and the…
Just a simple RatRig Logo spinner for Orbiter2. The STL is for a 8x3mm magnet. I have included the Fusion360 project where the Magnet diameter, Outer perimiter diameter and extrusion height is parameterized. Print is ASA, ABS or similar…
I wanted to mount this cool sheet holder on the side of my IKEA Lack enclosure, so I made this remix.
This IFP insert tool is made specific for Reverb Stealth C1 Dropper Posts. It inserts the IFP 55mm into the tube. It has a fat lip to prevent it from going in too far. It can be printet in any material that is not too soft. I have…
I needed good vertical front lighting in my Ikea Lack enclosure so I made these led mounts for aluminum rails that fit the Lack table legs. The aluminum profile is 17.9mm wide. I used 3 for each led strip. The aluminum rail is set in…
I wasn't a fan of the standard connector for the 4028 fan, so instead I made this connector that uses two 4 pin female JST connectors. It connects to the toolhead using the two back screws of the 4028. Print solid in PETG if not enclosed,…
My Ikea Lack enclosure has an airvent below the pavement stone, so I needed a riser to pull it of the base. This riser gives enough clearance for good air intake. There is little to no drag around the print bed, and with a decent filtered…
To wszystkie aktualnie dostępne wyniki.
