Liczymy pasujące modele…
I rescaled the original model and made it fit the 608ZZ bearings I already had. Successfully printed with 0.15mm resolution on Prusa Mini+. The bearing sits a bit tight in the hole, but can be pressed in with some force (maybe with the…
Ruler with foldout stencils for kids. Printing Needed: 1x Top 1x Connector 1x one of the Bottoms Note: Can be printed without supports. Assembly Push the Connector through the front face of the “Top” part. Then push the Bottom part over…
DISCLAIMER: Up to this point the "Sleeved" model versions are untested. However since they all have the same tolerances they should fit the same! This is a deckbox for trading cards I created to have additional storage space for dice,…
To bring some light into my 3D Printer enclosure, I printed these sockets to hold IKEA's HALVKLART LED-Spotlights in there. I added a visor to avoid looking directly into the lamps when inspecting my prints. Printing: Per Lamp you have to…
I designed this webcam mount to mount my Microsoft LifeCam HD-3000 into my printer enclosure. It is designed to be installed to one of the IKEA LACK table's hollow legs. Installation: Drill a 2cm hole into the LACK's leg Install the…
I was disappointed, when the original mounting brackets of my TREDANSEN blinds from IKEA left a tremendous gap to the wall, which let more line shine through than necessary. Therefore i created an adapter bracket that can be slit into…
This is a deckbox for trading cards. The design has an open front so the two halves can be used as library/graveyard stack. The lid and bottom are identcal parts. This makes it easy to print in multiple colors that can be recombined at…
After getting a dual-spool dryer i ran into an issue when trying to route one of the spools from the dryer to Tool 4 of the 5 tool Prusa XL. This attachment allows to install two bowden tubes below the base of the Prusa XL which allows to…
Some prints for magnetic attachment of IKEA's FISKBO frames to an enclosure made of IKEA's LACK tables. Printing: Most parts can be printed with no to little support. Choose one of the holes with one of the plug designs and print 4 of…
To wszystkie aktualnie dostępne wyniki.
