Liczymy pasujące modele…
This small part broke on my smart Roadster. You cannot get this little piece as a single spare part but need to buy the complete doorhandle with bowden and stuff instead … if you are lucky enough to get one at all. So I decided to design…
Die Abstandshalter von @lansolo81 funktionieren hervorragend. Allerdings steht der der Senkkopf der Spaxschrauben etwas über das Skadisbrett heraus. Der Remix behebt dieses kleine Manko durch ein etwas weiteres und tieferes Senkloch, das…
The Minisforum ITX boards support an unusual hole placing for the cooler mounts, 52mm on the edges. The model by NAnglo uses a slighty wider spacing, therefore I needed to adapt it a little bit. Print with temperature resistant and robust…
I wanted to optimize airflow for the BD790i inside my Fractal Ridge case. Played around with different fans and found out that the big NF-A15 and - even better - the newer NF-A14x25r do fit nicely in that setup. The new one even without…
Needed an adapter to fill my pool with air. This is a lot quicker with an air compressor than with a foot pump. Other designs didn't work out as I expected them, so I created this one within a few minutes. Best printed with TPU and 15%…
I printed the Aqara G4 cover by Ginbook ( https://www.printables.com/model/455462-cover-for-aqara-doorbell-g4 ) as it basically fits the updated G410 version of the doorbell. Unfortunately, the G410 has a stronger IR light. This, combined…
I used Prusa Slicer's cut feature to remove the excess slot(s). Prints perfectly fine without supports, just like the original. Used 15% infill and 0.25 draft profile with 3 perimeters with Geetech PLA. Accidental two colored print as my…
The original design is really nice, especially the USB icons. But I found the groove on the sides to be not very stable. Therefore, both sides of the groove now have the same thickness, making the piece more sturdy. Print Settings Printer…
I got an used VR100 as spare parts donor that was completely intact apart from a broken display and a the missing green handle that you need to lift the dustbin. So I re-created that little piece to complement the dustbin. Update: added a…
As I use them to mount them together with a Skadis board I needed more space to prevent shadowing. I just screwed them directly on the Skadis board, replacing the original Skadis screws.
Die Klemme fixiert das Abflussrohr samt Dichtung in der Wand. Sichert die Dichtung gegen Herausrutschen. Borhungen für 4,5mm Schrauben. Druck mit 3 oder mehr Perimetern für bessere Stabilität.
A simple and slightly reinforced replacement for the backcover of an Atari PC1 expansionslot. Print with 100% infill if you plan to drill holes in it. For best surface finish print with outside on textured sheet. Use of supports is…
The Berker K1 frames have a special rectangular format. Standard Berker adapter frames for 55mm square switches don't fit with the Meross switch cover. Therefore I needed to design a custom switch cover. The cover snaps perfectly into the…
To wszystkie aktualnie dostępne wyniki.
