Liczymy pasujące modele…
The roof and the base can be stuck or glued together, while the beam is used for sliding in and out to replace the picture. Both sides of the frame can be used as frame, so if you want to have 2 picturtes back-to-back for your desk, have…
I made it for being able to screw a M5 nut, which had only a small space for screwing (nut was nearly embedded in the destined place). The screwdriver is hollow so that the screw doesn't get in the way. Scale it up for bigger sizes…
Here are two versions of a ring holder that has an open ring for holding the ring (and a small bowl for rings in the middle (can be seen in the photo of m make). One can use the two- or four-arms version (I only printed the two arms…
I needed one to hold my projector remote, so the contest came to the right time, here my version. It is a rather simple print, the only “challenge” is, that it is slim and high, so without brim, it might topple over. I always use some…
Having something fancy for a single item, for that this shelf is the right thing. One could use it as a key holder, hold your wifi acccess point, or in my case, to hold the elixir of life, a pack of cofffee. The current design should be…
Remember the last time you came by a whiteboard and thought to yourself: “why can't I store my nerfgun bullets in a neat holder on that whiteboard?” No? Never had that thought? Oh, okay, then let's take plan B: Remember the last time you…
A very minimal version of a toothbrushholder for 2 OralB Toothbrushes. A primitive version of that model was actually my first FreeCAD model ever made 7 years ago. Its print is still in use, but I took the flash contest as an opportunity…
Made for the “last meter” contest. Although all parts together can be printed for less than 4m filament (not tested with the uploaded gcode, since I have no Prusa printer yet, but a comparable setup was used on my printer successfully,…
Made for the “last meter” contest. Although all four parts together can be printed for just under 5m filament (tight gcode settings to fulfill the contest requirement, not tested with them, I have no Prusa printer yet, but a comparable…
To wszystkie aktualnie dostępne wyniki.
