Liczymy pasujące modele…
As the description says. There is a left and a right part, you'll need both. Print orientation should be pretty obvious - just print it laying on the chamfered side of the model. I included the chamfer because elephant foot compensation…
As the description says. I didn't design this to be printed in a certain direction, but I printed so that the skådis hooks are printed horizontally. I only needed a few supports on the print-bed but your experience may vary so feel free…
As the description says. There are two different versions of this Holder. A regular one and one that is designed for a bit of extra padding, if you're worried about the plastic leaving marks on the rubber part of the drill (like I was).…
This is a holder for 7mm glue sticks (i.e. for Hoto's hot glue gun) that is compatible with Ikea Skådis. I designed them to be printed lying on the side - the small arch connecting the front and back walls shouldn't need any supports.…
As the description says. Technically its a holder for the drilling and screwing bit holder and not just the bits themselves but ‘hoto bits holder holder’ sounded a bit stupid :v As for orientation, I just printed them with the hooks being…
I built this thing so i can use my Vision Pro without the need for pockets. It can be worn like a chest-strap or pretty much anywhere on your waist. I'm using 2.5mm diameter elastic cord to keep the two case-halves together and 30mm wide…
To wszystkie aktualnie dostępne wyniki.
